Prices, Promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.
FAQs
How deep should underground sprinklers be? ›
Sprinkler lines should be buried below the grass roots, and deep enough the sprinkler heads sit flush with the soil surface or slightly above grade. The depth varies depending on factors but typically ranges from eight to 12 inches.
Are underground sprinklers worth it? ›An inground sprinkler system allows you to reduce the amount of water you use for your lawn and garden. A well planned system helps eliminate expensive runoff of residential water. Installing eco-friendly irrigation systems that are used properly keeps water waste to a minimum and saves money on water bills.
How long should you run underground sprinklers? ›How long should I run my sprinklers? You should run your sprinkler system for as long as it takes to apply a half inch of water to your lawn. You will need to water for at least 10 minutes per week for most systems. Measure your sprinkler system's output to ensure you're not using too much water or underwatering.
How long do underground sprinklers last? ›On average, lawn sprinkler systems last around 20 years before needing replacement. The main reason lawn sprinkler systems fail is wear and tear. Over time, the components of the sprinkler system will break down.
Can you install underground sprinklers yourself? ›It can save on utility costs and prevent soil erosion. With proper planning, you can do sprinkler installation yourself. All you need is time, some basic tools and a plan.
What kind of pipe do you use for underground sprinklers? ›PVC pipe (polyvinyl chloride pipe) is the most common irrigation material. The familiar rigid, white material is stronger than polyethylene. Connections are made with adhesive. Polyethylene is flexible, so it's often used in cold climates to adapt to extended freeze cycles.
Do you have to winterize underground sprinkler system? ›Wherever the frost level reaches below the depth of irrigation systems, winterizing can help prevent damage from freezing.
What is the best in ground sprinkler pipe? ›Polyethylene. Polyethylene pipes are mainly used in sprinkler systems because of their high-pressure rating. The rating system is basically a measurement of pressure-bearing load. Some particular environmental conditions require flexible pipes that can adjust to any changes.
How many sprinkler heads per zone? ›On average, a traditional sprinkler system zone boasts five to six rotary heads or eight to ten spray heads. At a minimum, you usually need four or five to cover a small square or rectangle.
What time of day is best to water a lawn? ›To water well, timing is everything. Water in the early morning – between 6 a.m. and 10 a.m. Midday watering leads to wasteful evaporation, while nighttime watering causes droplets to cling to grass overnight, increasing the chance of lawn diseases.
Do underground sprinklers need to be blown out? ›
Doing so prevents water freezing inside the irrigation pipes and system components which could cause cracks or damage. Blowing out your system is one of the best methods to ensure your irrigation system is completely dry.
How long does it take a sprinkler to put out 1 inch of water? ›It will take your sprinklers about one hour to put out the required one inch of water per week. Establishing a good irrigation schedule will help you achieve your lawn's water requirements.
Will inground sprinklers freeze? ›The water in the sprinkler pipes freezes and expands, damaging your underground system. As water freezes at 32 degrees Fahrenheit, a sprinkler system will freeze at that temperature.
How do you maintain an underground sprinkler system? ›Run the entire sprinkler system, one zone at a time.
- Check for damage to sprinkler heads or piping which could have occurred over the winter. Repair and replace as needed.
- Check for accurate spray patterns. ...
- Make sure sprinkler heads aren't blocked by plants or other materials.
Drip irrigation systems are the most cost-effective type of automatic sprinkler system. These systems deliver water directly to the plant roots, reducing evaporation and waste. This means they use less water than pop-up and rotor sprinklers, which can significantly save your water bill.
How deep to bury sprinkler wire? ›Mark the sprinkler locations with flags or the stakes. Typical trench depths range from 6 to 12 inches. To run pipe under existing walkways you can "drill" using water pressure. Get a piece of PVC long enough to go under the walk, glue a slip-female thread adapter to one end and attach a hose.
How deep do pop-up sprinklers need to be? ›A good rule to follow when considering the depth of a sprinkler system is, measure the body of your most commonly used sprinkler heads, then add 2 inches. For example, if you are using Rain Bird 1804 pop-up sprinkler heads, the body is 6”, so I would recommend that the sprinkler piping be 8 inches deep in this case.
How to find sprinkler lines without digging? ›Without digging, it is possible to find sprinkler lines by getting a design map from the company that installed the system. If this is not possible, one could go to the valve box and follow a line back to each of the head sprinklers in a circuit. Or one could utilize an electronic water-detection device.
How do you layout underground sprinklers? ›You need to plan and draw the layout for your main sprinkler line and lines for each zone. Use a direct route to draw the main sprinkler line from the main shut-off valve to the front and back yard manifolds. Important: Your main sprinkler line should be 1 size larger than the water main supply line.
